Home / Networking / Now you can 3D-print things that connect to Wi-Fi without batteries or electronics

Now you can 3D-print things that connect to Wi-Fi without batteries or electronics


diag.png

The researchers substituted electrical components with 3D-printable plastic springs, gears and switches, while an antenna was made from a plastic and copper conductive filament.


University of Washington

Researchers at the University of Washington have created a range of 3D-printed plastic objects that can communicate with a router even though they’re not connected to the internet and don’t contain any electronics.

The technique the researchers used to enable 3D-printed Wi-Fi is called ‘Wi-Fi backscatter’. It typically relies on electronic components to reflect or absorb radio signals from a Wi-Fi router.

They substituted electrical components with printable springs, gears and switches using plastic, while an antenna was printed with a conductive 3D-printing filament made of plastic and copper.

The idea is to print things like a sensor for a washing detergent bottle that can detect when it’s running low and communicate with a smartphone for reordering supplies.

The printed gear system encodes the 0s and 1s via the presence or absence of teeth in a plastic cog. The setup is also connected to a coil that toggles a switch made of conductive plastic that changes the state of the antenna.

Placed on a detergent bottle, the speed at which the gears turn estimates how much liquid is flowing out. A receiver can then monitor the bottle’s level and send a message to a smartphone app when it falls below a certain level.

The researchers also printed a wind meter, a water flow meter and a scale, as well as various widgets such as buttons, knobs and sliders.

Another technique they used to make 3D components that can communicate with smart devices was to create 3D-printed MagLink objects, which are encoded with magnetic fields.

For this system, the researchers used a Nexus 5’s magnetometers to receive data from the objects. The two different states are determined by the materials used to print the object. For 0 they used plastic and for a 1 they used a ferromagnetic plastic consisting of iron filings.

The researchers have released designs for the components as well as links to sources for materials.

Previous and related coverage

Is Germany right to tell parents to destroy kids’ smartwatches over snooping fears?

After banning smart dolls, Germany now says no to smartwatches that allow parents to listen in on classrooms.

Security vulnerability in IoT cameras could allow remote control by hackers

More Internet of Things security holes found in one of the most common forms of internet-connected cameras.



Source link

About admin

Check Also

AT&T Labs' Mazin Gilbert on AI, quantum computing, data collaboration and 5G

Dr. Mazin Gilbert, AT&T Labs’ vice president of advanced technology, is placing his research bets ...

Leave a Reply

Your email address will not be published. Required fields are marked *